Synchronizer rings for 1st, 2nd and reverse gears, checking for wear
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Check inner race on outer friction surface arrow for scoring or signs of wear, replace if necessary.
- Check synchronizer ring on inner friction surface arrow for scoring or signs of wear, replace if necessary.
- Place inner race, intermediate ring and synchronizer ring on selector gear taper or clutch hub taper and screw in.
NOTE:
- Screw in means: Turn synchronizer ring approx. one turn while pressing on the ring at the same time.
- Then measure gap - a - with a feeler gauge.
| Gap dimension - a - | Wear limit |
|---|---|
| 1st and 2nd gear | 0.7 mm |
| Reverse gear | 0.7 mm |
NOTE:
- Replace inner race, intermediate ring and synchronizer ring for the respective gear together.