Press needle bearing into transmission cover
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Install needle bearings with lettering on bearing (the side with thicker metal) facing towards thrust pad 3062.
- Press in needle bearing to a depth of 262 ± 0.5 mm, measured from housing joint surface to needle bearing (similar to Ill. A34-10190 Ball sleeve press-in depth in transmission cover ).
- Secure needle bearing after pressing into transmission cover with peen Secure needle bearing and roller housing in transmission cover with peen .