Detaching needle roller bearing from input shaft and installing needle roller bearing onto input shaft

WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Detaching Needle Roller Bearing From Input Shaft And Installing Needle Roller Bearing Onto Input Shaft

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Detaching needle roller bearing:

Bend open needle roller bearing at separating point - arrow B - far enough for it to be detached from input shaft (do not bend open more than necessary).

Installing needle roller bearing:

The shoulder - arrow A - faces toward splines for 2nd gear.

Only bend open needle roller bearing at separating point - arrow B - far enough for it to be guided over the input shaft and onto its seat - arrow C -.