Checking synchro-ring for wear
WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of VOLKSWAGEN UNITED STATES, INC.
- Press synchro-ring into locking collar and measure gap - a
- at positions - A
- , - B
- and - C
- using feeler gauge.
- Add measured values and divide by 3.
- The determined value should not exceed 0.45 mm.