Speedometer vehicle speed sensor -G22-, removing and installing

WARNING: This page is about a different car, the 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Fig 1: Identifying Speedometer Vehicle Speed Sensor (VSS) and O-ring

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Unplug connector of sender -A-.
Press down retainer, swivel sensor to one side and pull upward and out.

Installing

Replace O-ring -B- during installation.
Insert sensor and engage.

NOTE: Handle sender with care. If damaged, speed values can no longer be precise.