Defining thickness of shim "S3"
WARNING: This page is about a different car, the 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- The dimension "r" referenced to controller "Ro" is measured for the drive units which are delivered as replacement parts and written on the circumference of the ring gear.
- If measurement is performed in red zone measured value "e" must be deducted.
- If measurement is performed in black zone measured value "e" must be added on.
| Formula: |
| "S3" |
= |
"S3*" + "r" + "e" |
| ("e" in black zone) |
| "S3" |
= |
"S3*" + "r" - "e" |
| ("e" in red zone) |
| Example: |
|
| |
Inserted shim "S3*" |
0.60 mm |
| + |
dimension "r" |
0.38 mm |
| - |
obtained value "e" (red zone) |
0.26 mm |
| = |
Thickness of shim "S3" |
0.72 mm |
- Define shim(s) as accurately as possible using chart. Part numbers