Coolant pump, removing and installing: Installing

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, and 2003 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order, paying attention to the following:

Fig 1: Inserting Coolant Pump Into Cylinder Block And Securing Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Moisten new O-ring - 3 - with coolant.
Insert coolant pump into cylinder block and tighten securing bolts - 1 -.

Tightening torque: 15 Nm

Installing toothed belt and adjusting valve timing → Toothed drive belt, removing, installing and tensioning .

Install ribbed belt tensioning element.

Tightening torque: 25 Nm

Install ribbed belt → Ribbed belt, removing and installing .
Fill coolant system → Cooling system, draining and filling .