Intake camshaft oil seal, replacing: Removing

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, and 2003 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Cylinder head installed
Lock carrier in service position → Lock carrier, moving to service position .

Fig 1: Removing Engine Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove engine cover - arrows -.
Remove top section of toothed belt guard → Toothed drive belt, removing, installing and tensioning .

Fig 2: Locating Connector At Camshaft Position Sensor G40

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect connector from Camshaft Position (CMP) sensor G40 - arrow -.
Remove housing for CMP sensor G40.
Remove washer and CMP sensor rotor ring.

Fig 3: Adapter 2085/1 Threaded In Camshaft

Courtesy of VOLKSWAGEN UNITED STATES, INC.

To guide oil seal extractor, screw bolt 2085/1 into camshaft as far as it will go by hand.
Remove inner part of oil seal extractor 2085 two turns (approx. 3 mm) out of outer part and lock with knurled screw.

Fig 4: Screwing Threaded Head Of Seal Extractor With Forced Pressure Into Oil Seal

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Lubricate threaded head of oil seal extractor 2085 , place in position and exerting firm pressure screw as far as possible into oil seal.
Loosen knurled screw and turn inner part against camshaft until oil seal is pulled out.