Cylinder head cover, removing and installing: Installing
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, and 2003 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order, paying attention to the following:
NOTE:
- Replace gaskets and sealing rings.
- Replace cylinder head cover gaskets if damaged.
- First tighten inner nuts for cylinder head cover, then tighten outer nuts in diagonal sequence.
- Ensure that top section of toothed belt guard is seated correctly.