Checking actuation

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, and 2003 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying 2-Pin Electrical Connector & Terminals

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Connect voltage tester VAG 1527B to contact 1 (positive) and 2 of connector.
Start output Diagnostic Test Mode and actuate camshaft adjustment valve.

Indicated on display

Output Diagnostic Test Mode →
Camshaft timing control

LED must flash

If LED does not flash or if it is permanently lit:

Connect test box VAG 1598/31 to engine control module wiring harness. Engine control module must not be connected. → 24 - MULTIPORT FUEL INJECTION (MFI)

Fig 2: Identifying 2-Pin Electrical Connector & Terminals

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Check for open circuit and short to Ground/positive in following wiring connection:

Connector contact	Test box VAG 1598/31 socket
2	115

Eliminate any short circuits to Ground or open circuits.

If wiring is OK:

Replace engine control module.

If no malfunction is found:

Replace mechanical camshaft adjuster.