Dual-mass flywheel/drive plate, removing and installing: Removing

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, and 2003 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Reversing Position Of Counterhold 10-201 To Loosen/Tighten Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Reverse position of counterhold 10-201 to loosen/tighten bolts.
Mark position of flywheel relative to engine.
Unbolt and remove flywheel.

Fig 1: Securing Counterhold VW558 To Drive Plate

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Secure counterhold VW558 to drive plate using hex bolt M8 x 45 - 2-. Place two M10 hex nuts - 1 - between counterhold and drive plate.
Mark position of drive plate relative to engine.
Unbolt drive plate.