Balance Shaft Overview
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, and 2010 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Balance Shaft
- Removing and installing, refer to BALANCE SHAFT
- Bolt
- 60 Nm
- For loosening and tightening, use the locating pin T40116 as a counter holder
- Balance Shaft Transmission Side
- Can only be placed on the balance shaft in one position
- Gear Carrier
- Bolt
- 13 Nm
- Balance Shaft Belt Pulley Side
- Can only be placed on the balance shaft in one position
- Bolt
- 60 Nm
- For loosening and tightening, use the locating pin T40116 as a counter holder