LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (3.2L - Generic Scan Tool, Engine Code: BKH) >> ST - Generic Scan Tool >> Diagnostic Trouble Code (DTC) tables >> SAE P2xxx DTCs >> Transmission O9L

Transmission O9L

WARNING: This page is about a different car, the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
DTC Error Message Diagnostic Procedure Malfunction Criteria and Threshold Value Secondary Parameters with Enable Conditions Monitoring Time Length Frequency of checks, MIL Illum
P2637 Torque management Feedback Signal A CAN message signal error flag, = 1
  • Ignition, on
  • CAN Bus, OK
  • DME CAN connection, OK
 0.5 Seconds
  • Continuous
  • 2 DCY
P2714 Pressure Control Solenoid D Performance or Stuck off PWM hardware detection, 0 or 100%
  • Low side and high side FET, activated
  • Power supply, > 8.7 V
  • Voltage drop at FET, = 1 V
  • Solenoid supply, > 9 V
 0.05 Seconds
  • Continuous
  • 2 DCY
P2715 Pressure Control Solenoid D Stuck On PWM hardware detection, 0 or 100%
  • Low side and high side FET, activated
  • Power supply, > 8.7 V
  • Voltage drop at FET, = 1 V
  • Solenoid supply, > 9 V
 0.05 Seconds
  • Continuous
  • 2 DCY
P2716 Pressure Control Solenoid D Electrical
  • Current higher or lower than threshold, 730 mA
  • EDS output voltage at short to ground or open circuit ~ 0,5 V smaller than EDS supply voltage
  • Static leakage current flow
  • Off operation mode
 0.05 Seconds
  • Continuous
  • 2 DCY
P2723 Pressure Control Solenoid E Performance or Stuck off PWM hardware detection, 0 or 100%
  • Low side and high side FET, activated
  • Power supply, > 8.7 V
  • Voltage drop at FET, = 1 V
  • Solenoid supply, > 9 V
 0.05 Seconds
  • Continuous
  • 2 DCY
P2725 Pressure Control Solenoid "E" Electrical
  • Current higher or lower than threshold, 730 mA
  • EDS output voltage at short to ground or open circuit ~ 0,5 V smaller than EDS supply voltage
  • Static leakage current flow
  • Off operation mode
 0.05 Seconds
  • Continuous
  • 2 DCY
P2732 Pressure Control Solenoid F Performance or Stuck off PWM hardware detection, 0 or 100%
  • Low side and high side FET, activated
  • Power supply, > 8.7 V
  • Voltage drop at FET, = 1 V
  • Solenoid supply, > 9 V
 0.05 Seconds
  • Continuous
  • 2 DCY
P2733 Pressure Control Solenoid F Stuck On PWM hardware detection, 0 or 100%
  • Low side and high side FET, activated
  • Power supply, > 8.7 V
  • Voltage drop at FET, = 1 V
  • Solenoid supply, > 9 V
 0.05 Seconds
  • Continuous
  • 2 DCY
P2734 Pressure Control Solenoid "F" Electrical
  • EDS output voltage at short to ground or open circuit ~ 0,5 V smaller than EDS supply voltage
  • Static leakage current flow
  • Off operation mode
 0.05 Seconds
  • Continuous
  • 2 DCY
P2735 Pressure Control Solenoid "F" Intermittent PWM hardware detection, 0 or 100%
  • Low side and high side FET, activated
  • Power supply, > 8.7 V
  • Voltage drop at FET, = 1 V
  • Solenoid supply, > 9 V
 0.05 Seconds
  • Continuous
  • 2 DCY
scientia non olet · About LEMON Manuals