SUBFRAME Mount Overview

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, and 2010 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Subframe Mount Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 20 Nm
Mounting Plate
- For the engine mount
- If the engine mount is faulty, replace the retaining plate
- Check the retaining plate on the opposite side; replace if necessary
Bolt
- 40 Nm
Engine Support
Bolt
- 10 Nm
Heat Shield
Bolt
- 90 Nm plus an additional 90° turn
- Replace
Engine Mount
- Removing and installing: Left LEFT ENGINE MOUNT , right RIGHT ENGINE MOUNT
- Replace in pairs
Subframe
Bolt
- 55 Nm

Fig 2: Identifying Hydraulic Oil Hose Bracket -1- & Nut -2-

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nut -2- for the hydraulic oil hose bracket -1- to 9 Nm.