LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (3.0L - Cooling System - Engine Code(S): CCBA (Cabriolet)) >> 19 Cooling System >> Removal And Installation >> Left Front Coolant Pipes >> Removing

Left Front Coolant Pipes: Removing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, and 2010 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Engine Cover -1- And -2-
GWWA10-11070Courtesy of AUDI OF AMERICA, LLC

-- Remove the front engine cover -1- upward.

-- Remove the front noise insulation -1-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

Fig 2: Identifying Front Noise Insulation
GWWA10-11071Courtesy of AUDI OF AMERICA, LLC
Fig 3: Identifying Coolant Reservoir Marking
GWWA19-10535Courtesy of AUDI OF AMERICA, LLC
WARNING:

Risk of scalding due to hot steam and hot coolant.

  • The coolant system is under pressure when the engine is warm.
  • Cover the coolant reservoir cap with a cloth and then open it slowly to release the pressure.

-- Open the coolant reservoir cap.

-- Place the VAS 6208 under the engine.

NOTE:

The engine is not shown in the following illustrations.

Vehicles with Left Front Coolant Pipes, Version 1 

Fig 4: Identifying Hose Clamps -1 And 3- & Left Front Coolant Hose
GWWA19-10509Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -1 and 3-, then close off the coolant hoses with the 3094 and remove them from the left front coolant pipes.

-- Remove the bolts -2-.

Vehicles with Left Front Coolant Pipes, Version 2 

Fig 5: Locating Lower Coolant Pipe Bolt
GWWA19-10749Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the coolant hoses with the 3094 and remove them from the left front coolant pipes by loosening the clamps -arrows-.

-- Remove the bolt -1-.

All Vehicles 

Fig 6: Identifying Coolant Pipes
GWWA19-10917Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -1- and remove the coolant hoses from the coolant pipes on the A/C compressor.

-- Remove the bolt -2-.

-- Remove the front left coolant pipes downward.