Overview of selectable display group numbers
WARNING: This page is about a different car, the 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
| Display group number |
Display field |
Description |
Display field |
| 001 |
1 |
Control current for actuating A/C Compressor Regulator Valve N280 in amps |
|
| |
2 |
Activation for A/C Compressor Regulator Valve N280 in %
- Ratio of activation signal
|
|
| |
3 |
Signal from High Pressure Sensor G65 in %
- Signal ratio as a function of pressure in refrigerant circuit
|
|
| |
4 |
Pressure in refrigerant circuit in bar
- Calculated via ratio of signal from High Pressure Sensor G65 by operating and display module, Climatronic Control Module J255
|
|
| 002 |
1 to 4 |
The last four compressor shutoff criteria which were active for more than 20 or 12 seconds |
|
| 003 |
1 to 4 |
Left Temperature Flap Motor V158 |
|
| 004 |
1 to 4 |
Right Temperature Flap Motor V159 |
|
| Display group number |
Display field |
Description |
Display field |
| 005 |
1 to 4 |
Defroster Flap Motor V107 |
|
| 006 |
1 to 4 |
Central Air Flap Motor V70 |
|
| 007 |
1 to 4 |
Air Flow Flap Motor V71
- Left-hand drive vehicles
- Not used on right-hand drive vehicles (control motor not installed)
|
|
| 008 |
1 to 4 |
Recirculation Flap Motor V113 |
|
| 009 |
1 |
Measuring value of Left Footwell Vent Temperature Sensor G261 in °C |
|
| |
2 |
Measuring value of Right Footwell Vent Temperature Sensor G262 in °C |
|
| |
3 |
Measuring value of Left Vent Temperature Sensor G150 in °C |
|
| |
4 |
Measuring value of Right Vent Temperature Sensor G151 in °C |
|
| Display group number |
Display field |
Description |
Display field |
| 010 |
1 |
Measuring value of Evaporator Vent Temperature Sensor G263 in °C |
|
| |
2 |
Measuring value of Fresh Air Intake Duct Temperature Sensor G89 in °C |
|
| |
3 |
Calculated value transmitted by Instrument Cluster Control Module J285 (filtered value) for currently valid ambient temperature in °C |
|
| |
4 |
Measured value transmitted by Instrument Cluster Control Module J285 (non-filtered value) of Outside Air Temperature Sensor G17 in °C |
|
| 011 |
1 |
Measuring value of Instrument Panel Interior Temperature Sensor G56 in °C
- Installed in operating and display module, Climatronic Control Module J255
|
|
| |
2 |
Speed of Interior Temperature Sensor Fan V42
- Installed in operating and display module, Climatronic Control Module J255
|
|
| |
3 |
Coolant temperature in °C transmitted by Instrument Cluster Control Module J285 |
|
| |
4 |
Activation for output for idling speed increase
- From operating and display module, Climatronic Control Module J255 to relevant engine control module
- Display: "On" or "Off"
|
|
| Display group number |
Display field |
Description |
Display field |
| 012 |
1 |
Current engine speed in RPM transmitted by Instrument Cluster Control Module J285 |
|
| |
2 |
Vehicle speed in km/h transmitted by Instrument Cluster Control Module J285 |
|
| |
3 |
Status of torque required for compressor operation displayed in zone "4" |
|
| |
4 |
Engine torque in Nm required for compressor operation calculated by operating and display module, Climatronic Control Module J255 |
|
| Display group number |
Display field |
Description |
Display field |
| 013 |
1 |
Activation for Fresh Air Blower V2 in %
- Via Fresh Air Blower Control Module J126
|
|
| |
2 |
Speed of Fresh Air Blower V2 in RPM
- Calculated via ratio of signal from Fresh Air Blower Control Module J126 by operating and display module, Climatronic Control Module J255
|
|
| |
3 |
Voltage transmitted by Instrument Cluster Control Module J285 at terminal "58d" in % or V |
|
| |
4 |
Voltage transmitted by Instrument Cluster Control Module J285 at terminal "58s" in % or V |
|
| 014 |
1 |
Activation for Coolant Fan V7 in %
- From operating and display module, Climatronic Control Module J255 to relevant engine control module
- Engine control unit activates Coolant Fan Control (FC)Control Module J293
|
and |
| |
2 |
Feedback from relevant engine control module for activation of Coolant Fan V7 in % to Coolant Fan Control (FC)Control Module J293
- Only used on vehicles with operating and display module, Climatronic Control Module J255 as of hardware/software version "0203"
|
|
| |
3 |
Signal from Air Quality Sensor G238 |
|
| |
4 |
Request for fresh or recirculated-air mode |
|
| Display group number |
Display field |
Description |
Display field |
| 015 |
1 |
Activation for Heated Rear Window Z1
|
|
| |
2 |
Signal for activation of Heated Windshield Z2
- Only applicable to vehicles with Heated Windshield Z2 as optional extra
|
|
| |
3 |
Activation for supplementary heater
|
|
| |
4 |
Position of convertible top on Audi Cabrio
- Display only applicable to Cabrio
- Display: "Open" or "Closed"
|
|
| 016 |
1 |
Measuring value of Sunlight Photo Sensor G107
- Measured value for left side in Volts
|
|
| |
2 |
Measuring value of Sunlight Photo Sensor G107
- Measured value for left side in Watts per m 2
- Calculated by operating and display module, Climatronic Control Module J255 by way of measured voltage
|
|
| |
3 |
Measuring value of Sunlight Photo Sensor G107
- Measured value for right side in Volts
|
|
| |
4 |
Measuring value of Sunlight Photo Sensor G107
- Measured value for right side in Watts per m 2
- Calculated by operating and display module, Climatronic Control Module J255 by way of measured voltage
|
|
| Display group number |
Display field |
Description |
Display field |
| 017 |
1 |
Transmitted by Instrument Cluster Control Module J285, voltage at terminal "15"
|
|
| |
2 |
Transmitted by Instrument Cluster Control Module J285, voltage at terminal "75"
|
|
| |
3 |
Voltage from terminal "75" to operating and display module, Climatronic Control Module J255
|
|
| |
4 |
Voltage measured by operating and display module, Climatronic Control Module J255 at terminal "30" in V |
|
| 018 |
1 |
Standing time transmitted by Instrument Cluster Control Module J285
- Signal for "ignition off period" in hours
- Time since ignition last switched off
|
|
| |
2 |
Ignition key assignment transmitted by Instrument Cluster Control Module J285 |
|
| |
3 |
Windscreen wiper ON signal
- Wipe/wash or wipe mode
- Transmitted by Steering Column Electronic Systems Control Module J527
|
|
| |
4 |
Duty cycle for operating status of Fresh Air Blower V2 in %
- Calculated and transmitted by Fresh Air Blower Control Module J126
|
|
| Display group number |
Display field |
Description |
Display field |
| 019 |
1 |
Coding transmitted by Comfort System Central Control Module J393 and Instrument Cluster Control Module J285 (code "1") |
|
| |
2 |
Coding transmitted by Instrument Cluster Control Module J285 (code "2") |
|
| |
3 |
Display field not used |
|
| |
4 |
Display field not used |
|
| 020 |
1 |
Position in % of thumb wheel for Drivers Seat Heating Element installed in operating and display module, Climatronic Control Module J255
- Not applicable to vehicles with no "heated seat cushion" optional extra
|
|
| |
2 |
Measured actual temperature of driver seat cushion heater element in °C
- Not applicable to vehicles with no "heated seat cushion" optional extra
|
|
| |
3 |
Specified temperature of driver seat cushion heater element in °C
- Not applicable to vehicles with no "heated seat cushion" optional extra
|
|
| |
4 |
Activation for driver seat cushion heater element
- Display: "On" or "Off"
- Not applicable to vehicles with no "heated seat cushion" optional extra
|
|
| Display group number |
Display field |
Description |
Display field |
| 021 |
1 |
Position in % of thumb wheel for Front Passengers Seat Heating Element installed in operating and display module, Climatronic Control Module J255
- Not applicable to vehicles with no "heated seat cushion" optional extra
|
|
| |
2 |
Measured actual temperature of front passenger seat cushion heater element in °C
- Not applicable to vehicles with no "heated seat cushion" optional extra
|
|
| |
3 |
Specified temperature of front passenger seat cushion heater element in °C
- Not applicable to vehicles with no "heated seat cushion" optional extra
|
|
| |
4 |
Activation for front passenger seat cushion heater element on or off
- Display: "On" or "Off"
- Not applicable to vehicles with no "heated seat cushion" optional extra
|
|
| Display group number |
Display field |
Description |
Display field |
| 026 and 027 |
1 to 4 |
Ambient conditions under which pressure in refrigerant circuit was not OK
- Signal from High Pressure Sensor G65 outside permissible range
|
|
| 028 |
1 to 4 |
Display fields not used
- Operating and display unit, Climatronic Control Module J255 up to part No. with index "AH"
- Installed on vehicles up to VIN 399999 in Model Year 2005 (Saloon and Avant; gradual introduction for the Cabrio in week 46/04 without prior specification of any particular VIN
)
|
|
| |
|
Display of altered settings in the adaptation channels listed
- Operating and display unit, Climatronic Control Module J255 with part No. as of index "AJ"
- Installed on vehicles as of VIN 400000 in Model Year 2005 (Saloon and Avant; gradual introduction for the Cabrio in week 46/04 without prior specification of any particular VIN
)
|
|
| 081 |
1 |
Operating and display unit, Climatronic Control Module J255 up to hardware/software version "0610"
|
|
| |
|
Operating and display unit, Climatronic Control Module J255 as of hardware/software version "0711"
- Vehicle VIN transmitted by Instrument Cluster Control Module J285
|
|
| |
2 to 4 |
Display fields not used
- Intended for assembly and serial number of operating and display module, Climatronic Control Module J255 (introduction not yet finalized, No service relevance at present)
|
|
| Display group number |
Display field |
Description |
Display field |
| 125 |
1 |
Information from Instrument Cluster Control Module J285
- The information is transmitted on the CAN-Bus comfort system
|
|
| |
2 |
Information from Comfort System Central Control Module J393
- The information is transmitted on the CAN-Bus comfort system
|
|
| |
3 |
Information from Vehicle Electrical System Control Module J519
- The information is transmitted on the CAN-Bus comfort system
|
|
| |
4 |
Information from Steering Column Electronic Systems Control Module J527
- The information is transmitted on the CAN-Bus comfort system
|
|
| 126 |
1 |
Information from Auxiliary Heater Control Module J364
|
|
| |
2 |
Information from Convertible Top Control Module J256
- The information is transmitted on the CAN-Bus comfort system
- Only provided for Cabrio
|
|
| Display group number |
Display field |
Description |
Display field |
| 126 |
3 |
Display field not used
- Operating and display unit, Climatronic Control Module J255 up to part No. with index "G"
|
|
| |
|
Information from Instrument Cluster Control Module J285
- Only displayed by operating and display modules, Climatronic Control Module J255 with part No. as of index "H"
- The information is transmitted on the CAN-Bus comfort system
|
|
| |
4 |
Operating status of CAN-Bus comfort system |
|
Display groups not used at present for service purposes or not assigned
| Display group number |
Display field |
Description |
Display field |
| 023 to 025 |
1 to 4 |
Display fields not used
- These display groups cannot be called up by service personnel
|
|
| 029 to 079 |
1 to 4 |
Display fields not used
- These display groups cannot be called up by service personnel
|
|
| 080 and 082 |
1 to 4 |
Display groups currently not used for service purposes
- Display of manufacturer information for operating and display module, Climatronic Control Module J255
|
→
Display groups currently not to be used by dealerships |
| 083 to 124 |
1 to 4 |
Display fields not used
- These display groups cannot be called up by service personnel
|
|
| 127 |
1 to 4 |
Version numbers of operating and display module, Climatronic Control Module J255 |
→
Display groups currently not to be used by dealerships |