Display group "028"

WARNING: This page is about a different car, the 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Display of adaptation channels for which setting has been changed by way of "Adaptation" function

NOTE:

This display group is not used with operating and display modules, Climatronic Control Module J255 up to part number index "AH" (installed in vehicles up to VIN 399999 in Model Year 2005 for Saloon and Avant; gradual introduction for the Cabrio in week 46/04 without prior specification of any particular VIN ).
A maximum of 4 altered adaptation channels are displayed with operating and display modules, Climatronic Control Module J255 with part number index "AJ" onwards (installed in vehicles as of VIN 400000 in Model Year 2005 for Saloon and Avant; gradual introduction for the Cabrio in week 46/04 without prior specification of any particular VIN ). If changes have been made to the factory setting in more than 4 adaptation channels, these are no longer displayed (if applicable, reset adaptation of all adaptation channels by way of "Adaptation" function in adaptation channel "20" to factory setting → Climatronic Control Module J255, Adaptation (function 10) ).

Display field	Meaning	Remarks
1	Display = "0" (or display zone blank) No changes have been made to adaptation or all changes made have been reset to factory setting by way of "Adaptation" function in adaptation channel "20" Display = "XX" Changes have been made to setting in at least one adaptation channel Setting in this adaptation channel has been altered, check adaptation set → Climatronic Control Module J255, Adaptation (function 10)	The display sequence for the adaptation channels with altered setting is governed by the adaptation performed and the version of the operating and display module, Climatronic Control Module J255
2 to 4	Display = "0" (or display zone blank) No (or max. one, two or three) change(s) made to adaptation or all changes made have been reset to factory setting by way of "Adaptation" function in adaptation channel "20" Display = "XX" Changes have been made to setting in at least two, three or four adaptation channels Setting in this adaptation channel has been altered, check adaptation set → Climatronic Control Module J255, Adaptation (function 10)	The display sequence for the adaptation channels with altered setting is governed by the adaptation performed and the version of the operating and display module, Climatronic Control Module J255

Display field

Meaning

Remarks

Display = "0" (or display zone blank)

No changes have been made to adaptation or all changes made have been reset to factory setting by way of "Adaptation" function in adaptation channel "20"

Display = "XX"

Changes have been made to setting in at least one adaptation channel
Setting in this adaptation channel has been altered, check adaptation set → Climatronic Control Module J255, Adaptation (function 10)

The display sequence for the adaptation channels with altered setting is governed by the adaptation performed and the version of the operating and display module, Climatronic Control Module J255

2 to 4

Display = "0" (or display zone blank)

No (or max. one, two or three) change(s) made to adaptation or all changes made have been reset to factory setting by way of "Adaptation" function in adaptation channel "20"

Display = "XX"

Changes have been made to setting in at least two, three or four adaptation channels
Setting in this adaptation channel has been altered, check adaptation set → Climatronic Control Module J255, Adaptation (function 10)

The display sequence for the adaptation channels with altered setting is governed by the adaptation performed and the version of the operating and display module, Climatronic Control Module J255