Display group "007"
WARNING: This page is about a different car, the 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Air Flow Flap Motor V71
| Display field | Meaning | Remarks |
|---|---|---|
| 1 | Actual feedback value of Back Pressure Flap Motor Position Sensor G113 (in Air Flow Flap Motor V71) |
|
| 2 | Specified feedback value for Back Pressure Flap Motor Position Sensor G113 (calculated by operating and display module, Climatronic Control Module J255) |
|
| 3 | Value determined during "Basic setting" and stored in the operating and display module, Climatronic Control Module J255 for the Back Pressure Flap Motor Position Sensor G113 with control motor set to "Lower stop" (air flow/fresh-air flaps closed, recirculated-air mode) |
|
| 4 | Value determined during "Basic setting" and stored in the operating and display module, Climatronic Control Module J255 for the Back Pressure Flap Motor Position Sensor G113 with control motor set to "Upper stop" (air flow/fresh-air flaps open) |
|
- The following air conditioner operating statuses (and all intermediate settings) can be selected via the levers installed to the flaps depending on the position of the control motor:
- Air flow/fresh-air flaps closed and recirculated-air flap open = recirculated-air mode.
- Air flow/fresh-air flaps open and recirculated-air flap closed = fresh-air mode.
- Air flow/fresh-air flaps partially closed and recirculated-air flap closed = Air flow mode (feedback value in display zones "1" and "2" in range between approx. "110" and "170").
NOTE:
- With the vehicle stationary, the "air flow mode" setting is only attained during Output Diagnostic Test Mode (DTM) diagnosis.
- This control motor is used to activate the air flow/fresh-air flaps.
- This control motor is not installed on right-hand drive vehicles and this display group can therefore be ignored. On right-hand drive vehicles, the fresh-air flaps are moved by the Recirculation Flap Motor V113.
- The position of the air flow/fresh-air flaps is program-controlled in air flow mode. The flaps are closed as of approx. 80 km/h depending on vehicle speed, Fresh Air Blower speed, the selected and actually measured temperatures and the mode selected at the operating and display module, Climatronic Control Module J255. The air flow/fresh-air flaps are however not completely closed in air flow mode (they always remain open far enough to maintain the necessary air throughput).
- The notes on display group "003" also apply to this display group and should be observed if necessary.