Display group "006"
WARNING: This page is about a different car, the 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Central Air Flap Motor V70
| Display field | Meaning | Remarks |
|---|---|---|
| 1 | Actual feedback value of Central Flap Motor Position Sensor G112 (in Central Air Flap Motor V70) |
|
| 2 | Specified feedback value for Central Flap Motor Position Sensor G112 (calculated by operating and display module, Climatronic Control Module J255) |
|
| 3 | Value determined during "Basic setting" and stored in the operating and display module, Climatronic Control Module J255 for the Central Flap Motor Position Sensor G112 with control motor set to "Lower stop" (central and footwell flap closed, air flow is routed to defroster flap) |
|
| 4 | Value determined during "Basic setting" and stored in the operating and display module, Climatronic Control Module J255 for the Central Flap Motor Position Sensor G112 with control motor set to "Upper stop" (central flap open, footwell flap closed, air flow is routed to instrument panel vents) |
|
- The following air conditioner operating statuses (and all intermediate settings) can be selected via the levers installed to the flaps depending on the position of the control motor:
- Footwell and central flap closed = Defrost mode (air to windshield)
- Footwell flap open and central flap closed = Air to footwell (feedback value in display zones "1" and "2" between "110" and "150").
- Footwell flap closed and central flap open = Air from instrument panel vents
NOTE:
- The notes on display group "003" also apply to this display group and should be observed if necessary.