End Output (function 06)

WARNING: This page is about a different car, the 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Requirements:

DTC memory checked and erased, basic setting performed and coding checked → Climatronic Control Module J255, coding (function 07)

NOTE:

The currently valid code transmitted by the Instrument Cluster Control Module J285 is displayed in the measuring value block (display group "019") → Read Measuring Value Block (function 08) .

Fig 1: Locating Control Module Identification With Code Indicated On The Display

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Indicated on display of Diagnostic Operation System VAS 5051A :

Select function "06 - End of output".

Fig 2: Identifying Vehicle System Selection Prompt & "Scrolling" Bar

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Wait until this display (start menu) appears on Diagnostic Operation System VAS 5051A.
Switch off ignition and disconnect diagnostic connector.