Socket assignment for Test Box V.A.G 1598A with Adapter V.A.G 1598/11
WARNING: This page is about a different car, the 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- The terminal assignment of the connectors "A" and "B" for the Adapter V.A.G 1598/11 is not identical to the assignment of the sockets at the Test Box V.A.G 1598A.
- The terminal assignment of the connector "C" for the Adapter V.A.G 1598/11 is identical to the assignment of the sockets at the Test Box V.A.G 1598A.
- The terminal assignment of the connector "D" for the Adapter - 16 Terminals V.A.G 1598/12 is identical to the assignment of the sockets at the Test Box V.A.G 1598A.
- As the connectors to the operating and display module, Climatronic Control Module J255 are distributed over two adapters (Adapter V.A.G 1598/11 and Adapter - 16 Terminals V.A.G 1598/12), there is no Ground (GND) connection for test purposes with the Adapter V.A.G 1598/11 connected. When performing electrical checks, it is therefore necessary for various test steps to take measurements with respect to a suitable Ground (GND) point on the vehicle body or to use a second Test Box V.A.G 1598A (with the Adapter - 16 Terminals V.A.G 1598/12 connected, Ground (GND) is applied to socket "13").
| Connector "A" Terminal | Test Box V.A.G 1598A socket | Connector "B" Terminal | Test Box V.A.G 1598A socket | Connector "B" Terminal | Test Box V.A.G 1598A socket |
|---|---|---|---|---|---|
| 1 | 41 | 1 | 21 | 13 | 33 |
| 2 | 42 | 2 | 22 | 14 | 34 |
| 3 | 43 | 3 | 23 | 15 | 35 |
| 4 | 44 | 4 | 24 | 16 | 36 |
| 5 | 45 | 5 | 25 | 17 | 37 |
| 6 | 46 | 6 | 26 | 18 | 38 |
| 7 | 47 | 7 | 27 | 19 | 39 |
| 8 | 48 | 8 | 28 | 20 | 40 |
| 9 | 49 | 9 | 29 | ||
| 10 | 50 | 10 | 30 | ||
| 11 | 51 | 11 | 31 | ||
| 12 | 52 | 12 | 32 |