Removing And Installing The Large Locking Bushing -1- On The Gearshift Shaft
WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- The gearshift shaft must be removed.
- If the transmission is not disassembled, place a cloth in the opening for the gearshift shaft to prevent the locking bushing from falling into the transmission.
-- Remove the large locking bushing using the T40085 toward the inside, in the transmission cover.
-- Install the locking bushing using the T40085 to the installation dimension INSTALLED DIMENSION FOR THE LARGE LOCKING BUSHING -1- INSIDE THE TRANSMISSION COVER .