Removal And Installation: Piston: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, and 2010 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications, refer to PISTONS AND CONNECTING ROD OVERVIEW .

NOTE:

Replace bolts that are tightened to the specification.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston using a commercially available piston ring compressor.

Installed position:

Piston, refer to Figure.
Connecting rod, refer to Figure.

-- Install the connecting rod bearing cap according to the marking.

-- Install the upper oil pan. Refer to UPPER OIL PAN .

-- Installing cylinder head. Refer to CYLINDER HEADS .