Crankshaft Seal, Transmission Side

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, and 2010 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Assembly Tool T10122
Pulling Hook T20143/2
Assembly Device T10122/1
Pull Sleeve T10122/2

Procedure

Fig 1: Prying Out Sealing Ring Using Extractor Lever T20143/2

Courtesy of AUDI OF AMERICA, LLC

The transmission is removed. Refer to REMOVAL AND INSTALLATION or Removal and Installation .

-- Remove the drive plate. Refer to DRIVE PLATE .

-- Pry out the with a T20143/2.

-- Clean the running and sealing surface.

-- Place the T10122/1 on the T10122/2 and slide the shaft seal -A- onto the pull sleeve.

Fig 2: Identifying Seal, Sleeve T10122/1 And Assembly Tool T10122/2

Courtesy of AUDI OF AMERICA, LLC

-- Remove the assembly device.

-- Position the T10122/2 with shaft seal -1- on the crankshaft.

Fig 3: Identifying Pull Sleeve T10122/2 With Sealing Ring On Crankshaft

Courtesy of AUDI OF AMERICA, LLC

-- Press the shaft seal in evenly all around with the thrust piece T10122/3 until flush.

Fig 4: Pressing In Seal Evenly All Around Until It Reaches Stop Using T10122/3

Courtesy of AUDI OF AMERICA, LLC

-- Install the drive plate. Refer to DRIVE PLATE .