Transmission Neutral Position Sensor -G701-: Installing

WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the transmission neutral position sensor -- -A- with a new O-ring in the gearshift shaft cover -B-.

-- Tighten the new bolt -arrow- to the tightening specification TRANSMISSION NEUTRAL POSITION SENSOR -G701- .

-- Connect the connector to the transmission neutral position sensor -- -1-.

Fig 1: Identifying Connector To Transmission Neutral Position Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Install the noise insulation. Refer to NOISE INSULATION .