Tunnel CROSSMEMBER: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear noise insulation -2-. Refer to "Underbody Trim" in EXTERIOR EQUIPMENT (CABRIOLET) .

-- Mount the T10337 on the V.A.G 1383 A and attach it to the bottom of the transmission.

Fig 2: Mounting T10337 On V.A.G 1383 A And Attach It To Bottom Of Transmission

Courtesy of AUDI OF AMERICA, LLC

-- Raise the transmission slightly.

NOTE:

If the tunnel crossmember was removed in or to check or add transmission fluid, then it is necessary to bring the transmission back into its installed position after removing the tunnel crossmember. This is the only way the transmission fluid level can be adjusted correctly. Refer to TRANSMISSION FLUID LEVEL, CHECKING AND FILLING .

WARNING:

There is the risk of an accident.

The V.A.G 1383 A may only be used during assembly and must not sit unsupervised under the vehicle.

-- Remove the bolts from the tunnel crossmember -arrows-.

Fig 3: Identifying Bolts & Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrow- and the tunnel crossmember.

Fig 4: Identifying Nuts And Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC