Center Differential Housing, Installed Transmission And Attached Driveshaft: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications, refer to Specifications

NOTE:

Replace the bolts for the center differential housing.

-- Clean both housing separating surfaces thoroughly. They must be free of oil and grease.

-- Apply a bead sealant -arrow 1- evenly and not too thick on the housing surfaces; sealant,

Fig 1: Applying Sealant Bead On Housing Surface

GWWA39-10214

Courtesy of AUDI OF AMERICA, LLC

-- Place a sealing ring round each bolt hole to prevent contact corrosion -arrow 2-.

-- Coat the gear carrier surfaces with transmission fluid (MTF).

-- Coat both outer ring surfaces on the gear carrier slightly with transmission fluid (MTF).

Fig 2: Coating Both Surfaces On Gear Carrier Slightly With Transmission Fluid

GWWA34-10457

Courtesy of AUDI OF AMERICA, LLC

-- Insert the gear carrier.

Installed position: The tab on the gear carrier -arrow A- must fit into the opening in the transmission housing -arrow B-.

-- Place the center differential -2- on the transmission -1-.

Fig 3: Center Differential

GWWA34-10689

Courtesy of AUDI OF AMERICA, LLC

-- Mount the guide sleeve -4- on the center differential.

-- Install the pressure spring -3- into the center differential.

-- Press the center differential housing centrally on until it makes contact with the transmission housing and hold it securely.

Fig 4: Tightening Sequence, Center Differential Housing - Bolted Driveshaft

GWWA34-10435

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts for the center differential housing. Refer to Specifications .

-- Install the tunnel crossmember and tighten it. Refer to TUNNEL CROSSMEMBER, TRANSMISSION MOUNT AND TRANSMISSION SUPPORT OVERVIEW .

Fig 5: Identifying Bolts & Tunnel Crossmember

GWWA10-10866

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Check the vehicle data label or the designation on the rear final drive itself to determine which one is installed in the vehicle. Then select the correct rear final drive repair information.

-- Install the driveshaft. Refer to the appropriate service information .

-- MANUAL TRANSMISSION FLUID, FILLING .

-- Install the exhaust system free of tension. Refer to [For engine(s) CCBA] Description and Operation .

-- Install the subframe crossbrace. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .

-- Install the noise insulation. Refer to "Underbody Trim" in NOISE INSULATION .