Front Final Drive Sealing Rings Overview
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Flywheel
- Removing and installing, refer to Removal and Installation
- Shaft Seal
- For the left flange shaft
- Between the final drive and the transmission housing
- Replacing, refer to Removal and Installation
- Adjusting Ring
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- Differential
- Bolt
- Quantity: 10
- Tightening specification and sequence, refer to Specifications
- Locking Ring
- Replace
- Right Flange Shaft
- Removing and installing, refer to RIGHT FLANGE SHAFT
- Shaft Seal
- For the right flange shaft
- Replacing, refer to Removal and Installation
- Front Final Drive Cover
- Removing and installing, refer to Removal and Installation
- O-ring
- On the front final drive cover
- Replace
- Adjusting Ring
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- Spring Pin
- Gearshift Lever
- Shaft Seal
- For the selector shaft
- Removing and installing, refer to SELECTOR SHAFT SEAL
- Bolt
- Quantity: 3
- Tightening specification, refer to Specifications
- Left Flange Shaft
- Removing and installing, refer to Removal and Installation
- Gear Carrier
- Attached to the left flange shaft with the bearing -20- and the circlip -21-
- Bearings
- For the left flange shaft
- Pressed on to the left flange shaft
- Locking Ring
- For the left flange shaft bearing
- Replace
- Shaft Seal
- For the input shaft
- Replacing, refer to Removal and Installation