LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Final Drive, Differential - S-TRONIC Transmission 0B5 (Cabriolet)) >> 39 Final Drive, Differential >> Description And Operation >> Center Differential Housing With Connected Driveshaft Overview

Center Differential Housing With Connected Driveshaft Overview

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

REPAIR INFORMATION .

CLEAN WORKING CONDITIONS .

Fig 1: Center Differential Housing
GWWA39-10207Courtesy of AUDI OF AMERICA, LLC
  1. Bolt
  2. Bolt
    • Aluminum bolts
    • Quantity: 11
    • Tightening specification and sequence, refer to Specifications
  3. Housing
  4. Gear Carrier
    • Installed position: The tab must fit into the cut-out in the transmission housing.
  5. Center Differential
  6. Pressure Spring
  7. Guide Sleeve
    • Does not have to be installed again
  8. Locking Ring
    • For the transmission output shaft ball bearing with splines
    • Removing and installing, refer to Removal and Installation
  9. Locking Ring
  10. Ball Bearing
  11. Bolt
    • Steel bolts
    • Quantity: 2
    • Tightening specification and sequence, refer to Specifications
  12. Balance Weight
    • Installed depending on the version
  13. Shaft Seal
  14. Dust ring
    • Replace after removing
  15. Transmission Output Shaft with Splines without Vibration Damper
  16. Transmission Output Shaft with Splines and Vibration Damper
scientia non olet · About LEMON Manuals