LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1311 (Engine Assembly [CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB] (Cabriolet)) >> 10 Engine Assembly >> SUBFRAME Mount >> Overview - SUBFRAME Mount

Overview - SUBFRAME Mount

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2014 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Engine Mount
GWWA10-11044Courtesy of AUDI OF AMERICA, LLC
  1. Not Installed
  2. Bolt
    • 20 Nm
  3. Retaining Plate
    • For the engine mount
    • If the engine mount is faulty, replace the retaining plate
    • Check the retaining plate on the opposite side; replace if necessary
  4. Bracket
    • For the hydraulic line
    • Only for vehicles with hydraulic power steering
  5. Nut
    • 9 Nm
  6. Bolt
    • 40 Nm
  7. Engine Support
  8. Bolt
    • 10 Nm
  9. Heat Shield
  10. Bolt
    • 90 Nm +90° additional turn
    • Always replace
  11. Engine Mount
    • Left only with Left Electrohydraulic Engine Mount Solenoid Valve -N144- depending on equipment and version
    • Also right with Right Electrohydraulic Engine Mount Solenoid Valve - N145- depending on equipment and version
    • Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
    • Depending on the version replace in pairs.
  12. Subframe
  13. Bolt
    • 55 Nm
scientia non olet · About LEMON Manuals