Enable Condition

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

ENABLE CONDITION REFERENCE CHART

Secondary Parameters	Enable Conditions
Pump supply pressure check
Estimate ambient temperature	≥ 4.4 °C
Battery voltage	≥ 10.9 V
Barometric pressure	≥ 75 kPa (563 mmHg, 22.2 inHg)
Engine	In operation
Amount of intake air	≥ 2 g/s (0.07 oz/s)
Secondary air pump	Operating
Combination valve	Bank open (Except with both banks closed)
Combination valve one side closed pulse diagnosis
Estimate ambient temperature	≥ 4.4 °C
Battery voltage	≥ 10.9 V
Barometric pressure	≥ 75 kPa (563 mmHg, 22.2 inHg)
Engine	In operation
Feasible area for diagnosis	Value of Map 10 ≥ 1
After fuel cut	≥ 0ms
Combination valve both closed pulse diagnosis
Estimate ambient temperature	≥ 4.4 °C
Battery voltage	≥ 10.9 V
Barometric pressure	≥ 75 kPa (563 mmHg, 22.2 inHg)
Engine	In operation
Engine load	≥ 0.2 g/rev (0.01 oz/rev)
After fuel cut	≥ 1000 ms
Combination valve changeover pressure diagnosis
Estimate ambient temperature	≥ 4.4 °C
Battery voltage	≥ 10.9 V
Barometric pressure	≥ 75 kPa (563 mmHg, 22.2 inHg)
Engine	In operation
Amount of intake air	≥ 2 g/s (0.07 oz/s) and < 25 g/s (0.88 oz/s)
Engine speed	< 4000 RPM
After fuel cut	≥ 1000 ms
Overflow diagnosis
Estimate ambient temperature	≥ 4.4 °C
Battery voltage	≥ 10.9 V
Barometric pressure	≥ 75 kPa (563 mmHg, 22.2 inHg)
Engine	In operation