Selector Lever Cable, Removing And Installing: Installing

WARNING: This page is about a different car, the 2014 Audi A5, 2013 Audi A5, 2012 Audi A5, and 2011 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following:

Tightening specifications. Refer to OVERVIEW - SELECTOR LEVER CABLE .

NOTE:

Lubricate the cable eye and the ball socket on the selector lever cable with Polycarbamide Grease:G 052 142 A2 before installing.

-- Slide the noise insulation -2- over the opening on the selector lever cable -3-.

Fig 1: Identifying Sound Insulation And Lock Washers

Courtesy of AUDI OF AMERICA, LLC

-- Insert the O-ring -1- on the selector lever cable.

Fig 2: O-Ring, Selector Lever Cable And Clip

Courtesy of AUDI OF AMERICA, LLC

-- Install the selector lever cable -2- into the gearshift mechanism function unit in direction of -arrow-.

-- Secure the selector lever cable -2- with the clip -3-.

Installed position: the angled end of the clip -1- faces the selector mechanism.

Fig 3: Identifying Selector Lever Cable Retaining Clip Sideways & Selector Lever Cable From Shift Mechanism
Courtesy of AUDI OF AMERICA, LLC

-- Install the noise insulation -2- with four new lock washers -1-.

Fig 4: Identifying Sound Insulation & Lock Washers

Courtesy of AUDI OF AMERICA, LLC

-- Push the selector lever -1- on the transmission all the way to the back in direction of -arrow- until the parking lock locks into place.

Fig 5: Press Transmission Selector Lever Toward The Rear Until The Parking Lock Engages

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When parking lock is engaged, it must not be possible to turn the front wheels.

-- Press the selector shaft lever forward three detents so the transmission is in "D".

-- Make sure the selector lever inside the vehicle is also in "D".

-- Carefully press the selector lever cable ball socket -1- in this position onto the selector shaft lever.

Fig 6: Disconnect Electrical Connector On Transmission By Rotating Twist Lock Counter-Clockwise

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Do not bend selector shaft lever when pressing on, otherwise shift mechanism can no longer be adjusted exactly.

-- Attach the cable mounting bracket -2- and bolt to the transmission.

NOTE:

Do not bend or kink the selector lever cable.

Ignore -arrow-.

-- Secure the selector lever cable to the cable mounting bracket by tightening the lock nuts -item ) OVERVIEW - SELECTOR LEVER CABLE - Nut.

-- Check and adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Check the selector mechanism. Refer to SELECTOR MECHANISM, CHECKING .

-- Vehicles With A 3.2L FSI Engine: Install The Left Front Muffler. Refer to OVERVIEW - MUFFLER [CAEB, CPMA, CAED, CPMB] / FRONT EXHAUST PIPE, REMOVING AND INSTALLING [CAEB, CPMA, CAED, CPMB] .