Selector Lever Cable, Checking And Adjusting: Procedure

WARNING: This page is about a different car, the 2014 Audi A5, 2013 Audi A5, 2012 Audi A5, and 2011 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification. Refer to OVERVIEW - SELECTOR LEVER CABLE .

-- Pry the selector lever boot frame -1- out of the center console -arrows- using the :3409 .

Fig 1: Unclipping Mounting Frame For Selector Lever Boot From Center Console

Courtesy of AUDI OF AMERICA, LLC

-- Move the selector lever into "D".

Fig 2: Insert T40031 Through Opening In Selector Mechanism

Courtesy of AUDI OF AMERICA, LLC

-- Insert the :T40031 through the opening -arrow- in the selector mechanism and loosen the bolt on the selector lever cable approximately one turn.

NOTE:

Loosen the clamping screw approximately one turn but do not remove it.

The clamping screw is only accessible when the selector lever is in "D".

The selector lever must remain in "D" when the clamping screw is loose.

-- Carefully move the selector forward and back gently without shifting into another selector lever position. This releases the tension in the selector lever cable.

-- Move the selector lever into the "tiptronic gate".

NOTE:

Do not touch the selector lever during the adjusting.

-- Tighten the clamping screw in this position with the :T40031 without touching the selector lever.

-- Check the selector mechanism. Refer to SELECTOR MECHANISM, CHECKING .

If the shift mechanism does not function properly after adjusting selector lever cable:

-- Bring the selector lever cable into the basic setting. Refer to SELECTOR LEVER CABLE, BRINGING INTO BASIC SETTING .