Selector Lever Cable, Bringing Into Basic Setting: Procedure

• "Guided Fault Finding" with the Vehicle Diagnostic Tester is completed; all faults have been corrected.

-- Select the following menu items in Functions/Component Selection  "Guided Fault Finding" on the Vehicle Diagnostic Tester:

• Drivetrain 
• 0AW Transmission 
• 01 - OBD-Capable Systems 
• 02 - Transmission Electronics 
• 02 - Transmission Electronics, Functions 
• 02 - Measured Values 

-- Select the "driving mode" measured value from the list on the Vehicle Diagnostic Tester.

-- Compare the following displays:

• Measured value "driving mode" on the Vehicle Diagnostic Tester
• Selector lever position
• Selector Lever Transmission Range Position Display Unit -Y26- on the shift mechanism
• Transmission Range Display -Y6- in the instrument cluster

Conditions: 

• The displays must match

If the displays do not match:

-- Adjust selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING 

If the individual displays cannot be reached by adjusting the selector lever cable:

Selector Lever Cable, Bringing Into Basic Setting

Fig 1: Unclipping Mounting Frame For Selector Lever Boot From Center Console

Courtesy of AUDI OF AMERICA, LLC

• Tightening specification. Refer to OVERVIEW - SELECTOR LEVER CABLE .

-- Pry the selector lever boot frame -A- out of the center console -arrows- using the :3409  .

-- Move the selector lever into "D".

-- Insert the :T40031  through the opening -arrow- in the selector mechanism and loosen the bolt on the selector lever cable approximately one turn.

Fig 2: Insert T40031 Through Opening In Selector Mechanism

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ball socket -1- on the selector lever cable from the selector shaft lever using the :80-200  .

Fig 3: Disconnect Electrical Connector On Transmission By Rotating Twist Lock Counter-Clockwise

Courtesy of AUDI OF AMERICA, LLC

-- Press the selector shaft lever -A- on the transmission all the way back in direction of -arrow- until the parking lock engages.

Fig 4: Press Transmission Selector Lever Toward The Rear Until The Parking Lock Engages

Courtesy of AUDI OF AMERICA, LLC

• When parking lock is engaged, it must not be possible to turn the front wheels.

-- Press the selector shaft lever forward three detents so the transmission is in "D".

-- Make sure the selector lever inside the vehicle is also in "D".

-- Select 02-Measured Values  in Guided Fault Finding 02 Transmission Electronics  on the Vehicle Diagnostic Tester

-- Select Driving Mode  from the list.

-- Compare the following displays:

• "Driving mode measured value" on the Vehicle Diagnostic Tester
• Selector lever position
• Selector Lever Transmission Range Position Display Unit -Y26- on the shift mechanism
• Transmission Range Display -Y6- in the instrument cluster

Conditions: 

• The displays must match

-- Carefully press the selector lever cable ball socket -1- in this position onto the selector shaft lever.

Fig 5: Disconnect Electrical Connector On Transmission By Rotating Twist Lock Counter-Clockwise

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Check the selector mechanism. Refer to SELECTOR MECHANISM, CHECKING .