Transmission With A Long, Bent Oil Level Tube

WARNING: This page is about a different car, the 2014 Audi A5, 2013 Audi A5, 2012 Audi A5, and 2011 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Long Bent Oil Level Tube

Courtesy of AUDI OF AMERICA, LLC

-- Pull the oil level tube -A- out of the ATF check hole using the T-Handle Hook:3438 and let the remaining ATF drain out.

NOTE:

Shown in the illustration from the side in sections.

The oil level tube must be replaced.

-- Push the new oil level tube -A- into the ATF inspection opening -B-.

Fig 2: Identifying ATF Level Tube

Courtesy of AUDI OF AMERICA, LLC

Installed position: the large tab -1- on the ATF level tube must face the recess -2- on the ATF check hole.