Pressure Stand: T40099, Adapting To MULTITRONIC Transmission 0AW Fwd
WARNING: This page is about a different car, the 2014 Audi A5, 2013 Audi A5, 2012 Audi A5, and 2011 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- Input shaft is removed. Refer to INPUT SHAFT, REMOVING AND INSTALLING .
-- Place the input shaft centered directly on the :T40099 .
-- Mark the locations with color -arrow- where the alignment pins -1- are on the upper ring on the :T40099 with color.
- The marked location should be somewhat in the center between the connections -2- on the :T40099 .
-- Make a punch mark inside the marked field -a- = 6 mm from the inner edge and then make an 11 mm hole.
-- Make two cuts with a saw -arrow- as shown.
-- Remove any burrs on the saw cuts and the hole.