Dual Mass Flywheel, Removing And Installing: Installing
WARNING: This page is about a different car, the 2014 Audi A5, 2013 Audi A5, 2012 Audi A5, and 2011 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal while noting the following:
-- Always clean the clutch housing in the area where the differential is accessed -arrow A- and the shaft seal -arrow B-.
NOTE:
Replace the shaft seal between the differential and transmission housing -arrow B- if it is damaged. Refer to LEFT SEAL, REPLACING .
-- Fill the space between the sealing/dust lip halfway with Sealing Grease :G 052 128 A1 .
-- Clean the input shaft -arrow-.
-- Lubricate the input shaft splines using Grease for Clutch Plate Shaft Splines :G 000 100 .
-- Carefully mount the dual mass flywheel onto the input shaft -arrow- without tilting it.
-- Install the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .