Cruise control system, activating/deactivating

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Vehicles equipped with CCS, the CCS function must be activated after replacement of the engine control module.
If the CCS function is activated in the engine control module of a vehicle without CCS, a DTC memory entry is made. If this is the case, the CCS function must be deactivated.

Procedure

Connect vehicle diagnostic, testing and information system VAS5051. Refer to Vehicle diagnostic, testing and information system VAS5051, connecting and select functions and select vehicle system "01 - Engine electronics" in selection. Ignition must be switched on.

Fig 1: Diagnostic System VAS 5051: Display

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS5051:

Under -1- select diagnostic function "11 - Coding II".

All models

Fig 2: Diagnostic System VAS 5051: Display

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS5051:

1 - Enter code word

Activate CCS

Enter "11463" in zone -2- and confirm entry by pressing -Q- button.

Deactivate CCS

Enter "16167" in zone -2- and confirm the entry by pressing -Q- button.
Exit function "11 - Login, or function 11 - Coding II" by pressing ← button.

Fig 3: Diagnostic System VAS 5051: Display

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS5051:

Under -1- select diagnostic function "08 - Read measured value block".

Fig 4: Diagnostic System VAS 5051: Display

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS5051:

1 - Enter display group

Enter "066" for "display group number 066" in zone -2- and confirm entry by pressing -Q- button.

Fig 5: Diagnostic System VAS 5051: Display

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS5051:

Check indication in display field -2-.

	Display zones
	1	2	3	4
Display group 066: Signals to engine control module
Display	xxx km/h	XXXXXXXX	xxx km/h	XXXXXXXX
Display	ACTUAL speed	Switch settings	SPECIFIED speed	Switch settings
Range		0 = off 1 = on		0 = off 1 = on
Specified value		XXXX0XXX (if CCS not activated)		XXXXXXXX
		XXXX1XXX (if CCS activated)
	Value: X = no meaning

Exit function "08 - Read measured value block" by pressing ← button.
Press "06 - End output".
Switch ignition off.