Bolts And Nuts
WARNING: This page is about a different car, the 2014 Audi A5, 2013 Audi A5, 2012 Audi A5, and 2011 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the bolts opposite the tightening sequence.
- Nuts and bolts which secure covers and housings should be tightened in steps according to the specified tightening sequence and method.
- Nuts and bolts which secure covers and housings should be loosened and tightened crosswise in stages if no tightening sequence is specified.
- The tightening specifications apply to unlubricated bolts and nuts unless otherwise specified.
- Replace the self-locking nuts and bolts.
- If nothing else is specified: If the bolts that were installed with installed with a locking compound do not have to be replaced, then clean the thread with a wire brush. Install the bolts with Locking Fluid:AMV 185 101 A1 .
- Threaded holes used for self-locking bolts or bolts coated with locking fluid must be cleaned, for example with a thread tap. Otherwise there is a risk that the bolts will shear the next time they are removed.