Installing And Adjusting

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Position the lever/selector shaft on the transmission in the "N" position.

-- Install the Multifunction Transmission Range Switch -F125- onto the selector shaft.

-- Tighten bolts -arrows B- for the Multifunction Transmission Range Switch -F125- by hand.

Fig 1: Identifying Cap Nut, Cover, Locking Washer, Multi-Function Transmission Range (TR) Switch -F125- & Mounting Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the :T10173 on the selector shaft.

Fig 2: Identifying Gauge T10173 And Selector Shaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the selector lever cable.

-- Turn the multifunction transmission range switch -A- until the tab on the connector -arrow 1- locks into the groove on the :T10173 .

Fig 3: Identifying Gauge T10173 And Selector Shaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts -arrows- for the Multifunction Transmission Range Switch -F125-.

Fig 4: Identifying Cap Nut, Cover, Locking Washer, Multi-Function Transmission Range (TR) Switch -F125- & Mounting Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Now remove the :T10173 from the selector shaft.

-- Install selector lever cable.

Further installation is performed in the reverse order.

-- Check selector lever cable adjustment. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .