Overview - Oil Pump And Oil Pan Lower Section: Notes
WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 8 Nm + 90° (1 /4 turn) additional turn
- Replace
- Tighten diagonally in steps
- Bolt
- 9 Nm
- Replace
- Oil Baffle
- Oil Pump
- Do not disassemble
- With cold pressure relief valve 11 bar (160 psi) and pressure regulator valve 3.5 bar (50.76 psi)
- Removing and installing. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Bolt
- 24 Nm
- Alignment Sleeves
- Oil Pump Driveshaft
- Driver
- Pressure Spring
- Thrust Washer
- Chain Sprocket for Oil Pump
- Installation position: the lettering faces the engine
- Bolt
- 64 Nm
- To loosen, counterhold on sprocket with Wrench - Pin Type:3212 .
- If it is not possible to tighten the bolt to the specification, remove the oil pan lower section and the oil baffle and counterhold the bolt with an open end wrench on the oil pump driveshaft.
- To A/C Compressor Bracket
- O-Ring
- Replace
- Coolant Pipe
- Coolant Hose Connection Diagram. Refer to COOLANT HOSE CONNECTION DIAGRAM .
- Bolt
- 9 Nm
- Oil Pan Lower Section
- With Oil Level Thermal Sensor -G266-
- Clean sealing surface before installing
- Install with Silicone Sealant:D 176 501
- Removing and installing. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Oil Drain Plug
- M14: 30 Nm
- M24:50 Nm
- Seal
- Replace
- Oil Level Thermal Sensor -G266-
- Checking. Refer to appropriate service information.