Overview - Oil Pan Upper Section
WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
- Pressure Spring
- Driver
- Oil Pump Driveshaft
- Oil Pan Upper Section
- Clean sealing surface before installing
- Silicone Sealant:D 176 501
- Removing and installing. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Bracket
- For the electrical wiring harness
- Bolt
- 9 Nm
- Oil Pressure Regulation Valve -N428-
- Removing and installing. Refer to OIL PRESSURE REGULATION VALVE -N428-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Sealing Piece
- Quantity: 2
- Replace
- Bolt
- 9 Nm
- Tighten diagonally in steps
- Crankshaft Seal - Belt Pulley Side
- Replacing. Refer to CRANKSHAFT SEAL, BELT PULLEY SIDE, REPLACING .
- Right Idler Roller for Ribbed Belt
- Note location
- Right Idler Roller Cover
- Bolt
- 22 Nm
- Front Sealing Flange
- Removing and installing. Refer to FRONT SEALING FLANGE, REMOVING AND INSTALLING .
- O-Ring
- Replace
- Oil Pressure Switch -F22-
- 20 Nm
- Switching pressure 2.5 to 3.2 bar (36.25 to 46.41 psi)
- 2-terminal, gray insulation
- Removing and installing. Refer to OIL PRESSURE SWITCH -F22-, REMOVING AND INSTALLING .
- Seal
- Replace
- Bolt
- 9 Nm
- Sealing Plug
- The illustration does not show the version in the vehicle.
- O-Ring
- Replace
- Guide Tube for Gauge - Oil Gauge Tester:T40178
- Bolt
- 9 Nm
- O-Ring
- Replace
- O-Rings
- Replace
- Seal
- Replace
- Bolt
- 9 Nm
- Oil Return Pipe
- O-Ring
- Replace
- Seal
- Replace
- Alignment Sleeve
- Quantity: 2
- Bolt
- 14 Nm
- Tighten diagonally in steps
- Bolt
- 45 Nm
- Locking Bolt for "TDC" Opening
- 35 Nm
- Seal
- Replace