Heater And A/C Unit Actuators, Removing And Installing
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Prior to working on electrical wires, disconnect the corresponding fuse/fuses. Refer to Wiring Diagram.
NOTE:
After replacing an actuator, the address for all of the actuators must be adapted again using the Vehicle Diagnostic Tester.
For the malfunction "adaptation limit exceeded", check connecting element at motor/door, there must be no play between the shaft of the actuator motor and the connecting element.