Tightening Specification

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Component	Tightening Specification
Coupling rod to stabilizer bar Use new nut Tighten the threaded connection in the curb weight position. Refer to RAISING THE REAR AXLE TO THE CURB WEIGHT POSITION .	100 Nm
Coupling rod with spring shock absorber to wheel bearing housing Use a new bolt and nut Tighten the threaded connection in the curb weight position. Refer to RAISING THE REAR AXLE TO THE CURB WEIGHT POSITION .	90 Nm + 90°
Bolt for the cable bracket on the wheel bearing housing	10 Nm