LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1275 (Rear Suspension) >> 42 Rear Suspension >> SUBFRAME And Stone Deflector >> SUBFRAME, Removing And Installing >> Installing

SUBFRAME, Removing And Installing: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following: 

-- Tighten the subframe with the old bolts. After the axle alignment these must be replaced with new bolts.

-- Tighten the old bolts with the specified torque without additional tightening.

-- After installation, a vehicle alignment must be performed. Refer to WHEEL ALIGNMENT .

-- Bleed the brake system. Refer to BRAKE SYSTEM, BLEEDING .

-- Install wheels and tighten. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

scientia non olet · About LEMON Manuals