Tightening Specification

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Component	Tightening Specification
Rear upper transverse link to wheel bearing housing Use a new bolt and nut Tighten the threaded connection in the curb weight position. Refer to RAISING THE REAR AXLE TO THE CURB WEIGHT POSITION . Apply the specified torque via the bolt	150 Nm + 90°
Tie rod to steering knuckle Use a new bolt and nut Tighten the threaded connection in the curb weight position. Refer to RAISING THE REAR AXLE TO THE CURB WEIGHT POSITION . Apply the specified torque via the bolt	150 Nm + 90°
Spring shock absorber with coupling rod to wheel bearing housing Use a new bolt and nut Tighten the threaded connection in the curb weight position. Refer to RAISING THE REAR AXLE TO THE CURB WEIGHT POSITION .	90 Nm + 90°
Front upper transverse link to wheel bearing housing Use a new bolt and nut Tighten the threaded connection in the curb weight position. Refer to RAISING THE REAR AXLE TO THE CURB WEIGHT POSITION . Apply the specified torque via the bolt	150 Nm + 90°
Bolt for the cable bracket on the wheel bearing housing	10 Nm
Lower transverse link to wheel bearing housing Use a new bolt and nut Tighten the threaded connection in the curb weight position. Refer to RAISING THE REAR AXLE TO THE CURB WEIGHT POSITION .	150 Nm + 90°
Drive axle to wheel hub Use new nut	500 Nm