Tightening Specification

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Component	Tightening Specification
Transverse link to wheel bearing housing Use a new bolt and nut Tighten the threaded connection in the curb weight position. Refer to RAISING THE REAR AXLE TO THE CURB WEIGHT POSITION .	150 Nm + 90°
Transverse link to the front subframe Use a new bolt and nut Tighten the threaded connection in the curb weight position. Refer to RAISING THE REAR AXLE TO THE CURB WEIGHT POSITION . Apply the specified torque via the bolt	150 Nm + 90°
Transverse link to the rear subframe at the eccentric bolt Use new nut Tighten the threaded connection in the curb weight position. Refer to RAISING THE REAR AXLE TO THE CURB WEIGHT POSITION .	170 Nm
Steel spring shock absorber with coupling rod to wheel bearing housing Use a new bolt and nut Tighten the threaded connection in the curb weight position. Refer to RAISING THE REAR AXLE TO THE CURB WEIGHT POSITION .	90 Nm + 90°