Adapter For Assembling Flushing Circuit: Notes
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
-- The desiccant bag or dryer cartridge must always be removed before every flushing. Then reseal the receiver/dryer.
-- On condensers with a fixed dryer, it can be flushed with it. Then a new condenser must be installed.
NOTE:
If a flushed refrigerant circuit is not reassembled immediately after the flushing procedure, then the adapters must be left on the connections and seal the components that are still open with clean plugs from the Engine Bung Set:VAS6122
After completing the flushing procedure successfully, reassemble all adapters and replace the following components during assembly
- A/C compressor,
- Restrictor or expansion valve.
- Desiccant bag or dryer cartridge,
- High and low pressure side evacuating and charging valves,
- Seals.