Enable Conditions: Notes
WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
ENABLE CONDITION REFERENCE CHART
| Secondary Parameters | Enable Conditions |
|---|---|
| < Exhaust gas temperature diagnosis > | |
| Atmospheric pressure | ≥ 75 kPa (563 mmHg, 22.2 inHg) |
| Battery voltage | > 10.9 V |
| Engine condition | In operation |
| Vehicle speed | ≤ 2 km/h (1.2 MPH) |
| Misfire in 200 engine revs. | < 5 |
| Elapsed time after gear position change (P ↔ D or N ↔ D) | ≥ 3000 ms |
| ISC feedback | In operation |
| Throttle opening angle | < 0.37 ° |
| Fuel property | Not extremely low volatility |
| Target retard amount | ≥ 8°CA (AT model) |
| ≥ 8°CA (MT model) | |
| < Idle speed diagnosis > | |
| Atmospheric pressure | ≥ 75 kPa (563 mmHg, 22.2 inHg) |
| Battery voltage | > 10.9 V |
| Engine condition | In operation |
| Vehicle speed | ≤ 2km/h (1.2 MPH) |
| Misfire in 200 engine revs. | < 5 |
| Engine coolant temperature | ≤ 50°C (122°F) |
| Intake air amount sum value | ≤ Value of Map 1 |
| Elapsed time after gear position change (P ↔ D or N ↔ D) | ≥ 3000 ms |
| Throttle opening angle | < 0.37 ° |
| Fuel property | Not extremely low volatility |
| Elapsed time after starting the engine | ≥ 2000 ms |
| < Final ignition timing diagnosis> | |
| Atmospheric pressure | ≥ 75 kPa (563 mmHg, 22.2 inHg) |
| Battery voltage | > 10.9 V |
| Engine condition | In operation |
| Vehicle speed | ≤ 2 km/h (1.2 MPH) |
| Misfire in 200 engine revs. | < 5 |
| Engine coolant temperature | ≤ 50°C (122°F) |
| Intake air amount sum value | ≤ Value of Map 2 |
| Elapsed time after gear position change (P ↔ D or N ↔ D) | ≥ 3000 ms |
| Throttle opening angle | < 0.37 ° |
| Fuel property | Not extremely low volatility |
| Target retard amount | ≥ Value from Map 3 |