Round Connector Systems
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to SECONDARY LOCK .
-- Guide the release tool which fits the contact housing into release channel on contact housing.
-- Grasp contact at wire and push it gently into contact housing in direction of -arrow-.
NOTE:
By pushing the contact in the direction of the contact housing, the contact retaining tabs are lifted off the housing shoulder and can be released using the release tool.
-- At the same time, push release tool in direction of contact housing -arrow- and pull the released contact out of contact housing.
-- After removing the contact, release tool can be pulled out of the contact housing again.